Question I need help getting my memory setup

[Razoul1975]

I recently bought a new PC and wanted to upgrade the memory from 16 to 64 gigabytes. the ram is 4 16 gigabyte sticks of T-Force DDR5 Delta memory (FF4D532G6400HC32ADC01 16GBx4 DDR5 6400 (1Rx8) CL-32-39-39-84 1.35V) and my motherboard is a Gigabyte B650 Gaming wifi6. my system stats are

Processor AMD Ryzen 7 8700F 8-Core Processor 4.10 GHz
Installed RAM 64.0 GB (63.6 GB usable)
Device ID 75D85061-921D-44DF-AEE5-73B807EF61BA
Product ID 00342-21436-04562-AAOEM
System type 64-bit operating system, x64-based processor
Pen and touch No pen or touch input is available for this display

I've read that they can run stable at 6000Mhz but I don't know all of the voltages and such to use a custom Expo profile. If anyone can help I would very much appreciate it.

 

[Lutfij]

Welcome to the forums, newcomer!

the ram is 4 16 gigabyte sticks of T-Force DDR5 Delta memory (FF4D532G6400HC32ADC01 16GBx4 DDR5 6400 (1Rx8) CL-32-39-39-84 1.35V)

DELTA RGB DDR5 DESKTOP MEMORY WHITE 32GB(2x16GB) 6000MHz CL38 - TEAMGROUP

Desktop DDR5 Overclocked Memory with RGB Colors & 120° Ultra-Wide Lighting

www.teamgroupinc.com

Make sure you're on the latest BIOS version for your motherboard, then enable AMD's E.X.P.O in BIOS. You should be good to go without any tweaks besides enabling E.X.P.O in BIOS.

 

[SkyNetRising]

I've read that they can run stable at 6000Mhz but I don't know all of the voltages and such to use a custom Expo profile.

Show screenshots from CPU-Z - memory and spd sections.
(upload to imgur.com and post link)

 

[Unolocogringo]

This appears to be 2 kits of 32GB from the part numbers.
Mixing kits is always a gamble.
It might work might not.
Make sure kit 1 is in slots A1 and B1 and kit 2 is in A2 and B2.
do a hard bios reset.
Boot computer and let it try to boot for several minutes.
Give it time to retrain memory, it can take a while with 4 sticks.
If it boots and runs stable we can start with adjusting speed and latency.